|
ODORLESS LIQUID SYSTEM Usually sold to our European customers
as it is not hazerdous nor do customs agents have a problem
letting it enter European countries.
Directions for use are as follows below:
Directions for using ODORLESS LIQUID This applies to
all ODORLESS LIQUID AND POWDER
NO MATTER WHERE YOU BUY IT
ALL
"Odorless" acrylic systems work the same way. They actually
work much like UV Cured gels...in that they have
a "tacky residue"except they
don't need to be cured in a UV lamp. Once they are cured
or hardened, there will be a tacky layer and you must
remove this. The Odorless product that you received is to be applied like any
other acrylic product, and you can expect it to
be polymerized (hard) in four minutes. However,
it will 'look" like it is not done because it appears
to still be wet on top. That
is the "tacky residue" and you must remove it.
You can do
it in one of three ways...
1) leave it
for the four minutes and at the end of the four minutes
just RUB it off with a nail file. Underneath
is the hardened product.
2) Apply oil to
the nails during that four minute time period and that
will lessen the amount of residue, and you still remove
it with a file
3) Place the hands
in warm water during the set up period, and that will
produce the least amount of residue after the four minutes.
NOTE - you may also
try to remove the residue with a nail wipe and acetone...but
always after the four minute hardening period.
|
